Resistencias de Banda Mica

Diseño y manufactura de resistencias de Banda mica y cerámica.

Termostatos con Bulbo Capilar

Rango de control 50 a 350 Grados Centígrados, 25 A Max

Resortes Para Troquel

Diseño y Manufactura de Resortes Industriales, Troquel, Agrícola, Residencial...

Resortes Para Brincolín

Diseño y Manufactura de Resortes Industriales, Troquel, Agrícola, Residencial...

Termostatos de Contacto Ajustables

Termostatos ajustables tipo Plancha, Claxon, Ulanet...

Válvulas Neumáticas

SMC, FESTO NEUMATICS, PISCO, FABCO, CLIPPARD, BIMBA

Resistencias Para Parrillas Eléctricas

Resistencias eléctricas para Parrila, Hornos, Estufones, Freidoras

jueves, enero 31, 2013

Como Verificar si Funciona un Termostato de Bulbo Capilar?




Como Verificar si Funciona un Termostato de Bulbo Capilar?


Primero, desconecta el termostato. Enseguida configúralo a la temperatura mínima de control, en este caso sería a 50 Grados Centígrados.

Con la ayuda de un encendedor, calienta la punta del bulbo capilar, en pocos segundos, el mecanismo interno se deberá activar, haciendo un "CLICK".  Si eso sucede, tu Termostato de Bulbo Capilar, esta funcionando Bien.   En caso contrario, tienes que conseguir uno nuevo.
Y esta es una manera sencilla de comprobar  por que nuestro sistema de control no funcionan correctamente.  Saludos!!!

From Carlo's Desk...


miércoles, enero 30, 2013

No. RDA-22V24W | Resistencia de Radiación | DIRCASA



Diseño y manufactura de  Resistencia de Radiación.  Diferentes medidas y montajes. 

From Carlo's Desk...

LVTCJ-01 | Termocople de Bulbo Tipo "J" | DIRCASA


Diseño y manufactura de Termocoples a medida, Diametro y Longitud variables.  Fabricados en Acero Inoxidable 304, Terminales con Forro de Teflón, Fibra de Vidrio o Malla Metálica.

Envianos tus requerimientos!!!

From Carlo's Desk...

jueves, enero 10, 2013

E = IR: It’s Not Just a Good Idea, it’s the Law



I recently had a conversation with a customer that resulted in one of those forehead-slapping “duh” moments for me, and I thought it might be worth passing along.  Here’s the story:

The customer had an application that required an analog linear feedback sensor that provided an output of 1 volt to 5 volts over the linear stroke range. Now, a 1-5V output is not very common, and the particular sensor he was interested in was only available with either a 0-10V or a 4-20 mA output. What to do? Perhaps the answer should have been obvious to me, but it was the customer who provided the solution this time: “couldn’t I use a 4-20 mA output and 250 ohm resistor to get my 1-5V output?” Why, yes….yes you could (smack…..duh!). And I know it will work, because we have the law on our side. Ohm’s Law, that is: E = IR, or voltage equals current x resistance.

Let’s check it:

4 (mA) x 250 (ohms) = 1 (volt)
20 (mA) x 250 (ohms) = 5 (volts)

So there you have it. Take a very common 4-20 mA output and drop it across a 250 ohm resistor and, lo and behold, you have your less common 1-5V signal. And, if you do this conversion right at the input to the controller, you get the added benefit of increased noise immunity of the 4-20 mA signal.

And, yes, I’m sure I knew of this little trick at one time. Maybe the part of my brain where this information was stored got overwritten by the names of the contestants on The Amazing Race or by the rollout plans for my million dollar consumer product idea: Dehydrated Water (just add water). But let’s keep that just between us, ok?


From Carlo's Desk...

Resortes para Brincolín



Fabricamos resortes a medida para Brincolín.  Terminales especiales.



Surtimos a toda la República Mexicana.  Precios especiales por Volumen.

From Carlo's Desk... 

Resistencia de Inmesión para Fundir Plomo

#Dircasa cuenta con el servicio de diseño y manufactura de Resistencias  de Inmersión para fundir plomo.


Se pueden fabricar en voltajes 110vac, 220va y 480vac,  y calcular los watts óptimos para cualquier depósito.  El diámetro del tubo es de 1/2"  ó  5/8" .

Son resistencias fabricadas con acero inoxidable de la más alta calidad, con bushing de bronce para montaje, ó  nos adaptamos a sus requerimientos. Terminales de tornillo.

From Carlo's Desk...




Imprimir ó Bajar en Formato PDF!!!

Print Friendly and PDF
Related Posts with Thumbnails

Forma de Contacto:


Nombre: *
Email: *
Subject: *
Mensaje: *
Image Verification
captcha
Please enter the text from the image:
[Refresh Image] [What's This?]
Powered byEMF Form Builder
Report Abuse